Cisco OL-4015-08 Manual de usuario Pagina 193

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 192
545
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S9
CSCsj66400
Symptoms: Tracebacks and error messages seen on E2 POS LC when changing from the encap from
FR-HDLC encap
Conditions: Occurs when unconfiguring the Frame-relay interfaces to the default encap HDLC.
Workaround: There is no workaround.
CSCsj68219
Symptoms: Tracebacks and error messages are seen.
Conditions: Occurs when configuring SR APS.
Workaround: There is no workaround.
CSCsj72032
Symptoms: COPP fails after LC is reloaded.
Conditions: Occurs when LC should be reloaded.
Workaround: There is no workaround.
CSCsj72234
Symptoms: The standby crashes when the 3-port Gigabit ethernet card is in admin down state after
a switchover has happened
Conditions: The 3 port Gigabit Ethernet Card has to be in admin down mode and then 2 switchovers
need to be done to get into this situation.
Workaround: Use the no hardware-module slot <x> shut command on the LC and admin shut it
again.
CSCsj74724
Symptoms: When the router is in transit mode (SRP shut down), the show controllers command
will behave as follows:
LOS, LOF, and RDI signals are reported as if the SRP interface were up
Active defects are detected properly (SLOS SLOF PLOP) as if the SRP interface were up
Active defects will not get cleared even if the issue goes away until the SRP is brought up
FEBE messages are not reported
Conditions: Occurs on a Cisco 10720 Router with SRP card in shutdown mode.
Workaround: Use no shut command on the SRP interface without assigning it an IP address.
CSCsj77669
Symptoms: GRP may crash continuously on reload if a MFR interface in the router has bfd
neighbor command configured.
Conditions: Occurs when bfd neighbor command is configured on MFR interface.
Workaround: Issue send brk from “telnet>” prompt and boot the router with a boot image. Then
remove the “bfd neighbor” config from MFR and reload the router with the regular image.
CSCsj77998
Symptoms: BFD sessions do not come up on Cisco ISR routers.
Conditions: BFD sessions remain in down state and do not transition to up state on Cisco ISR
routers.
Workaround: There is no workaround.
Vista de pagina 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 677 678

Comentarios a estos manuales

Sin comentarios