Cisco OL-4015-08 Manual de usuario Pagina 496

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 495
848
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S
Alternate Workaround: Power down and power up the router.
CSCeg03606
Symptoms: Multicast VPN (MVPN) traffic does not resume.
Conditions: This symptom is observed on a Cisco 12000 series that runs a Cisco IOS interim release
for Release 12.0(30)S and that functions as a PE router that is configured for MVPN.
Workaround: Enter the clear ip mroute command.
CSCeg03885
This caveat consists of two symptoms, two conditions, and two workarounds, and only refers to
routers that are configured with MPLS TE tunnels:
Symptom 1: Momentary packet loss may occur during tunnel reoptimization, usually several times
between the creation of a new tunnel and the cleanup of the old tunnel. Sometimes, longer packet
loss may occur during tunnel reoptimization.
Condition 1: This symptom is observed on any MPLS TE tunnel when the reoptimized label
switched path (LSP) traverses a midpoint or headend router that runs Cisco IOS Release 12.0(25)S4.
Workaround 1: There is no workaround.
Symptom 2: Permanent bad labels may be present after MPLS TE tunnel reoptimization.
Condition 2: This symptom is observed on a router that runs a Cisco IOS image that does not include
the fix for CSCed21063 and that functions in a network in which some routers run Cisco IOS
Release 12.0(25)S4. With the exception of release 12.0(25)S4 itself, Cisco IOS software releases
that are listed in the “First Fixed-in Version” field at the following location are not affected:
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCed21063.
Workaround 2: There is no workaround. To recover from the symptoms, enter the shutdown
interface configuration command followed by the no shutdown interface configuration command
on the affected TE tunnel interface.
CSCeg05681
Symptoms: A CSC OIR may cause all line cards in a router to enter the disabled state and the
standby RP to reload continuously.
Conditions: The symptom is observed on a Cisco 12000 series that has dual PRPs and that runs a
Cisco IOS interim release for Release 12.0(30)S.
Workaround: There is no workaround.
CSCeg05925
Symptoms: After you have entered the shutdown interface configuration command followed by the
no shutdown interface configuration command on a VLAN interface, MPLS traffic is dropped.
Conditions: This symptom is observed only when MPLS static labels are configured. When an
MPLS TFIB entry is created using MPLS static labels and when you enter the shutdown interface
configuration command followed by the no shutdown interface configuration command on the
egress VLAN interface, the MPLS entry may be missing from the TFIB on the line cards or port
adapters.
Workaround: Enter the clear ip route command for the affected prefix.
CSCeg06154
Symptoms: A router crashes when you delete an MPLS subinterface by entering the no interface
command.
Vista de pagina 495
1 2 ... 491 492 493 494 495 496 497 498 499 500 501 ... 677 678

Comentarios a estos manuales

Sin comentarios