
554
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S8
Resolved Caveats—Cisco IOS Release 12.0(32)S8
Cisco IOS Release 12.0(32)S8 is a rebuild of Cisco IOS Release 12.0(32)S. The caveats listed in this
section are resolved in Cisco IOS Release 12.0(32)S8 but may be open in previous Cisco IOS releases.
This section describes only severity 1, severity 2, and select severity 3 caveats.
Basic System Services
• CSCee24395
Symptoms: A Cisco router may reload if SNMP GetNextObjectInstance request are processed at
clogHistoryEntry_get.
Conditions: This symptom is observed on a Cisco 7206VXR series router with NPE- 300 processor
board running IOS 12.2(13)T5.
Workaround: The work around is not to query the CISCO-SYSLOG-MIB. You may create a SNMP
view to exclude this MIB and attach this view to all communities configured on the device. This will
prevent any managers from accessing the CISCO-SYSLOG-MIB.
• CSCeg62070
Symptoms: Tracebacks or crash are seen during HTTP transactions with long URLs.
Conditions: The crash is seen when the length of any token in the URL of the request is excessively
long.
Workaround: Disable HTTP server using the no ip http server command.
• CSCsb22489
Symptoms: In the vrf-lite configuration , the superviser crashes when the vrfs are removed from the
configuration. The crash persists even on interchanging the Wanda card and SIP-2.
Conditions: The following commad results in a Software forced reload.
c7606-b(config)#no ip vrf cisco3
OSPF was the common protocol and the crash has not been reported when /jointfilesconvert/415844/bgp is configured on the
router.
Workaround: This is a repeatable bug and no workarounds are known at this point.
• CSCsi77185
Symptoms: The memd recarved on RSP never occur because of the VIP stuck trying to change the
MTU under Serial interface.
Before the changes:
=================
interface Serial5/0/1:1 mtu 2000 < ===== to be changed
ip address 10.10.10.1 255.255.255.0
no ip directed-broadcast no keepalive
After the changes:
===============
interface Serial5/0/1:1
Router(config-if)#mtu 900
RSP logged the follow messages:
=========================== 12:56:45:
%CBUS-3-CMD: Cmd failed: tx limit, response 0x8010, Serial5/0/1:1
-Traceback= 40349B68 404CFE38 404D5180 403C30B4 4037CF64 40390CF4 403F22C8 403F22B4
Router(config-if)#
Router(config-if)# 12:57:21:
Comentarios a estos manuales