Cisco OL-4015-08 Manual de usuario Pagina 90

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 89
442
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(33)S2
CSCsu21668
Symptoms: “carve-level 0” is being used in SY5 nodes (SIP-601) to avoid unnecessary buffer
recarving and subsequent traffic disruption.
Conditions:
carve-level 0
Workaround: There is no workaround.
CSCsu41968
Symptoms: On a Cisco 7500 with an HA setup, the “show controller t3” command is showing
framing as M23 on the active and as C-bit on the standby. So the “loopback remote” configuration
is rejected on the active and is accepted on the standby.
Conditions: This symptom is observed when the “show controller t3 1/1/0” command is issued.
Workaround: There is no workaround.
Further Problem Description: Because of the framing mismatch, the standby might crash due to sync
issues.
CSCsu45425
Symptoms: Label Forwarding Information Base (LFIB) shows incorrect information for Global
BGP prefix after route flap. LFIB/FIB shows prefix as having a tag when it should be not. Routing
table is correct.
Conditions: Occurred on a Cisco 12000 router running Cisco IOS Release 12.0(33)S1.
Workaround: Enter the clear ip route command.
CSCsu86371
Symptoms: The connect command that is used to configure FRoMPLS is rejected.
Conditions: This symptom is observed with E0/E2 cards and E3/E5 MFRs.
Workaround: There is no workaround.
CSCsv04345
Symptoms: A GRP crashes with DWDM.
Conditions: This symptom is observed when the “show controllers dwdm” command is issued.
Workaround: There is no workaround.
CSCsv21489
Symptoms: Traffic is dropped on an FR subinterface with IPHC configurations when the SPA
reloads.
Conditions: This symptom is observed when IPHC is configured.
Workaround: Shut/no shut the affected main interface (for the subinterfaces).
CSCsv30035
Symptoms: ICMP packets get corrupted when PXF is enabled.
Conditions: This symptom is observed when PXF is enabled.
Workaround: Disable PXF.
Vista de pagina 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 677 678

Comentarios a estos manuales

Sin comentarios