Cisco OL-4015-08 Manual de usuario Pagina 576

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 575
928
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S3
CSCeh60185
Symptoms: An Engine 4 plus (E4+) line card that functions in an IP-to-tag switching scenario may
generate “TX192-3-PAM_MODULE” and “%TX192-3-PAM_PIM” error messages and tracebacks
or may crash.
Conditions: This symptom is observed on a Cisco 12000 series when the ingress interface is an
Engine 2 line card that has an input ACL and when an external LDP flap occurs that affects the
Engine 4+ line card.
Workaround: There is no workaround.
CSCeh64632
Symptoms: After a route processor or line card has reloaded, the queue limit that is set for the class
default is not properly programmed.
Conditions: This symptom is observed on a Cisco 12000 series 1-port channelized OC-12/STM-4
(DS1/E1) ISE line card that has an egress policy applied to a serial interface.
Workaround: There is no workaround.
CSCeh65748
Symptoms: A Engine 3 ISE line card may not properly handle incoming bad IP packets but may
generate a traceback and a transient error message:
%GSR-3-INTPROC: Process Traceback= 400E10B4 400FBA2C
-Traceback= 4047917C 405E5274 400F4B58
%EE48-3-BM_ERRS: FrFab BM SOP error 40000
%EE48-3-BM_ERR_DECODE: FrFab SOP macsopi_bhdr_pkt_len_zero_err
%GSR-3-INTPROC: Process Traceback= 400E1090 400FBA2C
-Traceback= 4047917C 405E5274 400F4B58
%LC-4-ERRRECOVER: Corrected a transient error on line card.
The line card may also crash.
Conditions: These symptoms are observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(26)S1 or Release 12.0(26)S5a.
Workaround: There is no workaround.
CSCeh73978
Symptoms: When configuring service policies on any interface, the console erroneously displays a
message indicating that Rate Limit and Policing can only be configured together on 4 port ISE
Ethernet cards. More importantly, it prevents the service policy from being applied to the interface.
Conditions: This symptom has been observed on startup or anytime the configuration is entered.
Workaround: There is no workaround.
CSCeh84320
Symptoms: The subinterface on the modular GE/FE card stops forwarding.
Conditions: This symptom occurs whenever the operator enters sub-interface mode with an
xconnect statement on the EPA-GE/FE-BBRD fixed port on the modular GE/FE card.
Workaround: While in the sub-interface mode, the operator can enter a shutdown command
followed by a no shutdown command which allows the subinterface to resume forwarding.
Vista de pagina 575
1 2 ... 571 572 573 574 575 576 577 578 579 580 581 ... 677 678

Comentarios a estos manuales

Sin comentarios