
547
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S9
Workaround: Copy the startup configuration to the running configuration.
• CSCsj93388
Symptoms: 12000-SIP-501 reloads with the following error message:
%RP-3-FABPINGTIMEOUT: Fabric ping timeout
Conditions: This problem is seen when executing the following commands
Router#attach <slot number>
LC-SlotX>show controllers tofab queues outputq 0 2303 drr
Workaround: Enter valid queue numbers for “start_q” and “end_q” values in the command. Valid
Queues are as follows.
–
0 - 2047 (Low Priority ToFab Unicast Queues)
–
2048 - 2055 (ToFab Multicast Queues)
–
2176 - 2191 (High Priority Tofab Unicast Queues).
The problem is not seen when DRR information is read for valid queues.
• CSCsj94561
Symptoms: A router may crash because of a bus error when you perform an OIR of a PA-MC-8TE1+
port adapter or when you enter the hw-module slot slot-number stop command for the slot in which
the PA-MC-8TE1+ port adapter is installed.
Conditions: This symptom is observed on a Cisco 7200 series.
Workaround: There is no workaround.
• CSCsj97877
Symptoms: When E4P is egress and policing is configured in the policy, matching ip prec did not
match labelled packets and matching exp did not match pure IP packets.
Conditions: When E4P is egress and policing is configured in the policy, matching ip prec did not
match labelled packets and matching exp did not match pure IP packets.
Workaround: Match exp for labelled packets and ip prec for pure IP packets.
• CSCsj98594
Symptoms: SIP-600/601 LC reloads.
Conditions: Occurs on slow path.
Workaround: There is no workaround.
• CSCsj98725
Symptoms: The following traceback occurs when some policy/class addition/deletion or interface
flaps is done:
SLOT 2:Jan 25 19:13:34 UTC: ee192_tx_q_cleanup_guts(): EE_QM_QOS_INTERNAL_ERROR
Conditions: It happens when some policy or class addition/deletion or interface flaps is done.
Workaround: Reload the LC to bring the LC-Resources to normal state.
• CSCsj98774
Symptoms: When changing the APS mode using aps unidirectional or no aps unidirectional the
following error message may be seen:
%SONET-4-APSMM: SONET9/0 (grp 1 chn 0: ACTIVE): APS mode mismatch - switching to
unidirectional mode
Comentarios a estos manuales