Cisco OL-4015-08 Manual de usuario Pagina 295

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 294
647
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S
Workaround: Do not configure SSO as the redundancy mode. Rather, configure RPR+ as the
redundancy mode.
Alternate Workaround: Disable the SNMP MIB notification log by entering the no snmp mib
notification-log default command.
CSCsa92394
Symptoms: A router may crash while loading the image for a secondary RSP from a disk during the
boot process.
Conditions: This symptom is observed on a Cisco 7500 series that is configured with redundant
RSPs when the hw-module slot slot-number image disk0: image command is configured.
Workaround: There is no workaround.
CSCsa98777
Symptoms: An MSFC may reload when the standby Supervisor Engine 720 is inserted. Similarly,
the active Route Processor (RP) may reload when the standby RP is inserted.
Conditions: These symptoms are observed on a Cisco Catalyst switch or router when SNMP and
SSO are configured, and when the following configuration is present on the platform:
snmp mib notification-log default
snmp mib notification-log globalageout 600
snmp mib notification-log globalsize 1500
Workaround: Do not configure SSO. Rather, configure RPR+.
Alternate Workaround: Remove the SNMP MIB notification-log configuration by entering the no
snmp notification-log default command.
CSCsb08386
Symptoms: A router crashes when you enter the show ip /jointfilesconvert/415844/bgp regexp command.
Conditions: This symptom is observed on a Cisco router when BGP is being updated.
Workaround: Enable the new deterministic regular expression engine by entering the /jointfilesconvert/415844/bgp regexp
deterministic command and then enter the show ip regexp command. Note that enabling the new
deterministic regular expression engine may impact the performance speed of the router.
CSCsb14026
Symptoms: A standby RSP reloads continuously.
Conditions: This symptom is observed on a Cisco 7500 series that is configured for SSO and that
has the snmp mib notification-log default command enabled.
Workaround: Disable the snmp mib notification-log default command.
CSCsb14371
Symptoms: A Cisco 7500 series may log the following error message even if no VIP is installed in
slot 0:
%IPC_RSP_CBUS-3-NOHWQ: Hardware queue for card at slot 0 not found
Conditions: This symptom is observed after a crash of another VIP has occurred. Sometimes the
symptom occurs when a VIP is installed in slot 0 but most of the time there is no VIP in slot 0 when
the symptom occurs.
Workaround: There is no workaround.
CSCsb44308
Symptoms: A Cisco router or switch may crash when you enter the no snmp-server command.
Vista de pagina 294
1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 677 678

Comentarios a estos manuales

Sin comentarios