
673
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S
Further Problem Description: The fix for this caveat enables the ISE line card to drop the
above-mentioned bad packets.
• CSCeh49892
Symptoms: The following incorrect error message is generated when an invalid QOS policy is
applied to an L2 ATM interface before a valid policy is applied:
Remove existing Service-policy CBR before applying new Service-policy egress
Conditions: This symptom is observed only on a Cisco router that is configured with a secondary
RP and ATM L2VPNs that function in the VP mode.
Workaround: There is no workaround.
• CSCeh50638
Symptoms: A 4-port Gigabit Ethernet ISE line card may crash.
Conditions: This symptom is observed on a Cisco 12000 series that is configured for multicast
traffic.
Workaround: There is no workaround.
• CSCeh51720
Symptoms: When the router is configured with a new area, the links that are configured for TE are
not flooded in the new area.
Conditions: This symptom is observed when you configure an area by entering the mpls traffic-eng
area number command as part of the router OSPF configuration.
Workaround: There is no workaround.
• CSCeh52241
Symptoms: Fault recovery may fail to recover memory contents on ECC faults for certain FSRAM
memory locations.
Conditions: This symptom is rarely observed on a Cisco 12000 series.
Workaround: There is no workaround.
• CSCeh53373
Symptoms: A TE tunnel does not come up.
Conditions: This symptom is observed in an MPLS TE interarea configuration.
Workaround: There is no workaround.
• CSCeh54615
Symptoms: LSPs that support AToM circuits may fail to come up.
Conditions: This symptom is observed on a Cisco router that runs a Cisco IOS software image that
includes the fix for DDTS ID CSCeg74562. A list of the affected releases can be found at
http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCeg74562. Cisco IOS
software releases that are not listed in the “First Fixed-in Version” field at this location are not
affected.
Workaround: There is no workaround.
• CSCeh55841
Symptoms: When you remove one CSC or one SFC, all traffic stops because there is insufficient
fabric bandwidth. However, when you re-insert the CSC or SFC, all interfaces remain down.
Conditions: This symptom is observed on a Cisco 12000 series.
Comentarios a estos manuales