
971
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S
Conditions: This symptom is observed in a stress situation when bursty traffic is received.
Workaround: There is no workaround.
• CSCed54080
Symptoms: Per-VPN per-destination loadbalancing does not operate correctly on an Engine 2 or 4+
and there seems to be loadsharing only on BGP nexthop.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(23)S4.
Workaround: The clear ip route vrf vrf-name command invokes a recalculation of the hashes. Also,
the clear ip /jointfilesconvert/415844/bgp neighbor soft command (can) reassign(s) new labels and respread(s) the load.
These commands may impact service by stopping traffic forwarding.
• CSCed55201
Symptoms: A serial interface may stop transmitting, and the following error message may be
generated:
%RSP-3-RESTART: interface Serial1/0/2, not transmitting
-Traceback= 403D8D88 403E2830 4036B72C 4036B718
Conditions: This symptom is observed on a Cisco 7500 series that is configured with an 8-port serial
V.35 port adapter (PA-8T-V35).
Workaround for HDLC interfaces: Disable CDP, the passive interface, and the outbound IP ACL.
Workaround for Frame Relay interfaces: Disable CDP, the passive interface, the outbound IP ACL,
and LMI.
• CSCed63508
Symptoms: Up to 10 percent of packets that are larger than 1496 bytes are dropped when passing
through an Engine 3 4-port GE line card (4GE-SFP-LC).
Conditions: This symptom is observed on a Cisco 12000 series when the line card is used for both
the ingress and egress traffic flow. This situation occurs when SNF is configured on the egress
interface of the affected line card by entering the ip route-cache flow sampled output command.
Workaround: Increase the MTU on any interface of the Engine 4-port GE line card to 1530 bytes to
enable the buffer resources of the line card to be initialized with a larger size.
Alternate Workaround: Decrease the rate of packets drops by increasing the sampling period. For
example, when you enter the ip flow-sampling-mode packet-interval 10 command, up to 10
percent of packets that are larger than 1496 bytes are dropped. However, when you enter the ip
flow-sampling-mode packet-interval 1000 command, only 0.1 percent of packets that are larger
than 1496 bytes are dropped.
• CSCed64702
Symptoms: On a Cisco 10000 series, the PXF information may not be correctly updated from the
RP after a route change, causing packets to be sent untagged even though the RP shows that the
packets should be sent as tagged.
Conditions: This symptom is observed on a Cisco 10000 series that runs Cisco IOS
Release 12.0(26)S.
Workaround: Enter the clear isis * command or enter the shutdown command followed by the no
shutdown command on the interface towards the MPLS cloud.
• CSCed67734
Symptoms: Packet processing at the remote end of a link may fail.
Comentarios a estos manuales