Cisco OL-4015-08 Manual de usuario Pagina 650

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 649
1002
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S
%LCINFO-3-CRASH: Line card in slot 4 crashed
Conditions: The symptom is seen when the ciscoOpticalMonitoringMIB is polled on a router
running Cisco IOS Release 12.0(27)S1. The card that crashes does not have to be the card that is
being polled. For example, an OC192E/POS-VSR in slot 0 may be polled with
1.3.6.1.4.1.9.10.83.1.1.1.1.8.2 and the OC192E/POS-IR-SC in slot 4 may crash.
Workaround: Stop the crashes by configuring an SNMP view that prevents the
ciscoOpticalMonitoringMIB from being polled.
CSCef25953
Symptoms: DSCP-based DWRED statistics are not updated in output of the show policy-map
interface command: random drop and tail drop statistics are always shown as zero.
Conditions: This symptom is observed on a Cisco 7500 that is configured with an RSP4. However,
this caveat may be platform-independent.
Workaround: There is no workaround.
CSCef26053
Symptoms: Load-balancing does not work over a BGP multipath. Some of the traffic may be
forwarded correctly while other traffic may be forwarded unlabeled into the MPLS core.
Conditions: This symptom is observed on a Cisco router that functions as a PE router when the
following conditions are present:
The affected route is in a VRF.
One of the paths is learned from a CE router via an eBGP multihop session.
The eBGP multihop peer (that is, the CE router) is reachable through the MPLS core and the
BGP session does not involve a label exchange.
Workaround: Avoid a multihop eBGP session in which the CE router is reachable through the MPLS
core. For example, instead of a configuration in which the CE router connects to the PE router across
the MPLS core, configure the CE peer to connect to a local PE router that redistributes the routes it
has learned from the CE peer to other PE routers. (The local PE router may need to be configured
for eiBGP multipath.)
CSCef26077
Symptoms: Unconfiguring link bundling on a GE interface causes a bus error on the RP.
Conditions: This symptom is observed on a Cisco 12000 series that runs a Cisco IOS interim release
of Release 12.0(30)S. However, this caveats is resolved in Release 12.0(30)S.
Workaround: There is no workaround.
CSCef26186
Symptoms: After a router reloads, Engine 0 POS and Engine 4+ POS line cards may reset because
of an “%MDS-2-LC_FAILED_IPC_ACK” error.
Conditions: This symptom is observed on a Cisco 12000 series that runs the gsr-p-mz image of an
interim release for Cisco IOS Release 12.0(30)S and that has multicast enabled in global
configuration mode. Note, however, that this caveat is resolved in Release 12.0(30)S.
Workaround: There is no workaround.
CSCef26370
Symptoms: When you copy a Cisco IOS image or any other file to a PC flash card via TFTP, a very
high rate of out-of-sequence packets occurs, which can be seen in the “!0!00!0!00!0!0...” output of
the copy tftp slot-number command.
Vista de pagina 649
1 2 ... 645 646 647 648 649 650 651 652 653 654 655 ... 677 678

Comentarios a estos manuales

Sin comentarios