Cisco OL-4015-08 Manual de usuario Pagina 76

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 75
428
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(33)S2
Test 1:
c. show ip /jointfilesconvert/415844/bgp ipv4 multicast nei 10.0.101.2
d. show ip /jointfilesconvert/415844/bgp ipv4 multicast [<prefix>]
e. config terminal
The crash does not happen for each of the following cases:
1. If the same CLI is cut and paste manually, there is no crash.
2. If the clear cli command is not executed, there is no crash.
3. If the config terminal command is not entered, there is no crash.
Conditions: The symptom occurs after executing the above CLI.
Workaround: There is no workaround.
CSCsm80425
Symptoms: A Cisco 7200 device crashes when a policy map is applied.
Conditions: This symptom is observed when the service policy map is applied on the channelized
E3 interface of a Cisco 7200 VXR router and traffic is pumped.
Workaround: Remove the service policy map.
CSCsm96785
Symptoms: You may observe a problem which the OSPF neighbor is down after switch-over in spite
of using OSPF Non-Stop Forwarding (NSF).
Conditions: This occurs with the following conditions:
“nsf cisco” is only affected. If “nsf ietf”, this problem does not occur.
You may observe this problem if the OSPF interface is “point-to-multipoint non-broadcast” or
“point-to-multipoint”. If the interface is “broadcast”, this problem does not occur.
When this problem occurs after switch-over, DBD packet may not be exchanged between two
neighbors. And the neighbor is down in spite of NSF.
Workaround: Change the OSPF config to “nsf ietf” and change the OSPF interface to “broadcast”.
CSCsm96842
Symptoms: The command hold-queue length in cannot be configured for port-channel interface.
Conditions: The symptom is observed with a Cisco 7600 series router after upgrading to Cisco IOS
Release 12.2(33)SRC.
Workaround: There is no workaround.
Further Problem Description: Queueing is not supported for port-channel with a Cisco 7600 series
router. The hold-queue is a legacy queueing command and is not supported.
CSCso15740
Symptoms: The “set metric” clause in the continue route-map sequence is not setting metric
correctly in some particular conditions. This is also applicable in case where the nexthop setting is
done via route-map with a continue clause.
Conditions: The symptom is observed on a Cisco 12000 series router that is running Cisco IOS
Release 12.0(32)SY4. This is platform independent. This symptom occurs if the route-map has a
continue clause and the match condition does not allow the continue clause to be executed. The
following route-map sequence which has to be executed will not execute properly if the metric or
nexthop of the prefix are to be modified via the route-map.
Vista de pagina 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 677 678

Comentarios a estos manuales

Sin comentarios