Cisco OL-4015-08 Manual de usuario Pagina 296

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 295
648
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S
Conditions: This symptom is observed after a switchover when you enter the no snmp-server
command on the newly active RP or Supervisor Engine.
Workaround: There is no workaround.
CSCsb98906
Symptoms: A memory leak may occur in the “BGP Router” process.
Conditions: This symptom is observed on a Cisco router that runs Cisco IOS Release 12.0(26)S6,
that is configured for BGP, and that has the /jointfilesconvert/415844/bgp regexp deterministic command enabled.
Workaround: Disable the /jointfilesconvert/415844/bgp regexp deterministic command.
IBM Connectivity
CSCeg10448
Symptoms: DLSW transparent redundancy does not function via a Fast Ethernet port adapter.
Conditions: This symptom is observed when you use a Fast Ethernet port adapter with a particular
third-party vendor chipset.
Workaround: Use a port adapter that uses a different chipset.
Interfaces and Bridging
CSCee22523
Symptoms: A VIP that contains a PA-A3-OC12 ATM port adapter may unexpectedly reload.
Conditions: This symptom is observed on a Cisco 7500 series that functions in an ATM LANE
configuration.
Workaround: There is no workaround. The traffic on the VIP is disrupted until the VIP comes back
up.
CSCef01220
Symptoms: A Versatile Interface Processors (VIP) with a PA-MC-8TE1 port adapter may report its
memory size as unknown even though the VIP appears to function normally, and Distributed
Multicast Fast Switching (DMFS) may fail to function properly.
Conditions: This symptom is observed on a Cisco 7500 series when any of the following conditions
are present:
The mode of the controller of the PA-MC-8TE1 port adapter is not set to T1 or E1 and you insert
or remove another VIP with any port adapter via an OIR.
Irrespective of whether or not the mode of the controller of the PA-MC-8TE1 port adapter is set
to T1 or E1, you insert or remove a standby RSP via an OIR.
Workaround: Enter the card type {t1 | e1} slot [bay] command on the PA-MC-8TE1+ port adapter
and ensure that none of the controllers on this port adapter are shut down.
CSCef49896
Symptoms: Packets that enter an interface that is configured for IP may not be switched via dCEF.
Conditions: This symptom is observed on a Cisco 7500 series.
Workaround: Enter the shutdown interface configuration command followed by the no shutdown
interface configuration command on the affected interface.
Vista de pagina 295
1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 677 678

Comentarios a estos manuales

Sin comentarios