Cisco OL-4015-08 Manual de usuario Pagina 507

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 506
859
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S
Conditions: This symptom is observed on a Cisco router that is configured for Multiprotocol Label
Switching (MPLS) LDP and that has failed to establish an LDP session with some peers.
Workaround: Configure Tag Distribution Protocol (TDP) as the MPLS label protocol.
CSCeg88815
Symptoms: A PRP crashes after you remove a PVC from a main interface of a 4-port OC-12 ATM
ISE line card that has an outbound service policy enabled.
Conditions: This symptom is observed on a Cisco 12406 that runs a Cisco IOS interim release for
Release 12.0(31)S and that is configured with redundant PRPs when you remove a PVC with a
“255/255” configuration.
Workaround: There is no workaround.
CSCeg89117
Symptoms: A segment base is not freed, causing a memory leak.
Conditions: This symptom is observed when you unconfigure xconnect over an L2TPv3 connection.
Workaround: There is no workaround.
CSCeg89202
Symptoms: When you attach a policy with a priority class to a subinterface of a channelized
OC-48/STM-16 (DS3/E3, OC-3c/STM-1c, OC-12c/STM-4c) POS/SDH ISE line card that is
configured with Frame Relay subinterfaces, the default queue limit for the priority queue of the port
changes to a value that is calculated by the policy map that was attached. This situation causes QoS
to be impacted.
Conditions: This symptom is observed on a Cisco 12000 series.
Workaround: Ensure that the policy map that you attach last calculates the desired queue limit,
which is then applied to all subinterfaces of the port.
CSCeh00169
Symptoms: After you have reloaded a router, for each of the service policies that are attached to the
interfaces of a 4-port OC-12 POS ISE line card, the policing of L2 VCs may fail when errors with
the following associated error messages occur:
"Must remove existing service policy first .."
or
"Configured exceed actions are not supported when policing L2 VCs on interface.."
When the policing of L2 VCs fails, the following error message is generated:
"L2 policing config failed."
Conditions: This symptom is observed on a Cisco 12416 that runs the c12kprp-p-mz image of a
Cisco IOS interim release for Release 12.0(31)S and that is configured with dual PRPs and 4-port
OC-12 POS ISE line card that has a service policy attached to each of its interfaces.
Following are examples of configurations that may trigger the symptoms:
policy-map testing-input
class class-default
police cir percent 2 pir percent 4
conform-action set-mpls-exp-imposition-transmit 4
exceed-action set-mpls-exp-imposition-transmit 1
violate-action drop
!
Vista de pagina 506
1 2 ... 502 503 504 505 506 507 508 509 510 511 512 ... 677 678

Comentarios a estos manuales

Sin comentarios