Cisco OL-4015-08 Manual de usuario Pagina 534

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 533
886
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S5
CSCej14847
Symptoms: Auto-RP messages from a CE router are lost.
Conditions: This symptom is observed when you enter the clear ip mroute * on a connected PE
router. The messages do not recover by themselves.
Workaround: To restart Auto-RP messages, enter the clear ip mds linecard command.
Alternate Workaround: To restart Auto-RP messages, debug the VRF Auto-RP by entering the
debug ip pim vrf vrf-name auto-rp.
CSCej15698
Symptoms: The output of the show ip mroute vrf vrf-name active command shows an incorrect
entry or rate for decapsulated traffic.
Conditions: This symptom is observed on a Cisco 12000 series that is configured for mVPN.
Workaround: There is no workaround.
CSCej32588
Symptoms: An interface of an Engine 6 line card is no longer shut down after an RP switchover
occurs.
Conditions: This symptom is observed on a Cisco 12000 series when the following events occur:
1. The interface of the Engine 6 line card is configured with the no shutdown interface
configuration command in the startup configuration.
2. The router is reloaded and you verify that the interface comes up.
3. You enter the shutdown interface configuration command on the interface.
4. You enter the write memory command.
5. You enter the redundancy force command.
After the new RP comes up, the interface appears no longer shut down and the interface comes up
again.
Workaround: After you have entered the shutdown interface configuration command on the
interface followed by the write memory command, reload the router.
CSCej40549
Symptoms: A primary SR-APS physical interface may flap for several minutes in a scaled
configuration with 1000 VCs that are configured while the router boots.
Conditions: This symptom is observed on a Cisco 12000 series that runs the c12kprp-p-mz image,
that is configured with a 4-port OC-3 ATM ISE line card or 4-port OC-12 ATM ISE line card, and
that has SR-APS enabled.
Workaround: There is no workaround.
CSCej42144
Symptoms: A service policy on an Engine 4 + or Engine 6 line card is incorrectly rejected with the
following error message:
%E4P and E6 LC requires to configure POLICE and SET %command in every class if either
of these two commands %is configured in class-default class
This situation occurs when a set command is used in all classes.
Conditions: This symptom is observed on a Cisco 12410 that runs Cisco IOS Release 12.0(28)S3,
that is configured with dual Performance Route Processors (PRP-1s) that operate in SSO mode, and
that has multiple E4+ and/or Engine 6 line cards.
Vista de pagina 533
1 2 ... 529 530 531 532 533 534 535 536 537 538 539 ... 677 678

Comentarios a estos manuales

Sin comentarios