
620
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S3
IP Routing Protocols
• CSCsc73598
Symptoms: The IGP metric is not updated to an eBGP peer when there is an IGP- metric change.
The BGP peer is not advertising this change after its default timer of 10 minutes.
Conditions: This symptom occurs when a link goes down and the IGP metric to reach the BGP
nexthop has changed. When used in a route-map, the set metric-type internal value should
propagate any MED changes in updates to the BGP peers.
Workaround: Use clear ip /jointfilesconvert/415844/bgp neighbor-address [soft [in | out]] on the respective router to get the
correct metric changes and BGP best path.
• CSCsd66372
Symptoms: A Cisco 12416 router running the Cisco c12kprp-k3p-mz.120-31.S1.bin image
restarted.
Conditions: The symptom has been observed when using the Cisco c12kprp-k3p- mz.120-31.S1.bin
image. The following message was shown:
*Dec 31 14:53:04.667 EST: %SYS-5-CONFIG_I: Configured from memory by console
*Dec 31 14:53:05.163 EST: %SYS-5-RESTART: System restarted
Unexpected exception to CPUvector 300, PC = 98AFEC
-Traceback= 98AFEC 98AB18 1203EA0 98C3C0 98C678 98D20C 2CE86C
Workaround: There is no workaround.
Miscellaneous
• CSCec40013
Symptoms: When using the redundancy force-switchover command, a Cisco 12000 router may
reload with bus error.
Conditions: This symptom has been observed on a Cisco 12000 router running Cisco IOS
Release 12.0(26)S4 and with redundancy SSO enabled.
Workaround: There is no workaround.
• CSCej25402
Symptoms: Standby RP reboots continuously on STANDBY HOT (SSO) mode.
Conditions: This symptom occurs after loading the image and configuring SSO mode.
Workaround: There is no workaround.
• CSCek24285
Symptoms: After configuring a feature bundle on an E3 4x1GE line card and reloading, the line card
crashes when IPv6 traffic is processed by the line card.
Conditions: The symptom has been observed after the feature bundle is configured, the line card is
reloaded, and as soon as IPv6 traffic is processed by the line card.
Workaround: Remove the feature bundle configuration.
Comentarios a estos manuales