Cisco OL-4015-08 Manual de usuario Pagina 541

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 540
893
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S5
CSCsc18258
Symptoms: When you attempt to attach a child service policy to a parent shaper on a 4-port GE ISE
line card, the configuration is rejected with the following error message:
% Not enough bandwidth resources on interface GigabitEthernet3/0.275 to satisfy
request.
In this context, the error message is supposed to mean that the guaranteed bandwidth of the child
policy exceeds the rate of the parent shaper. However, when the symptom occurs, the configuration
is rejected even when the child bandwidth is less than the parent shaper rate.
Conditions: This symptom is observed on a Cisco 12000 series after the child policy is added and
removed a number of times and occurs because of leaking bandwidth in the bandwidth management.
Workaround: There is no workaround. To clear the symptom, reload the affected line card.
CSCsc30289
Symptoms: When the router at the opposite site is reloaded, a Dynamic Packet Transport (DPT) line
card crashes because of a “Bus Error exception.
Conditions: This symptom is observed on a Cisco 12000 series when the router at the opposite site
is also configured with a DPT line card.
Workaround: There is no workaround.
CSCsc30648
Symptoms: A POS line card that is configured with third-party vendor Small Form-Factor Pluggable
Interface Converters (SFPs) and that is installed in a Cisco 12000 series fails the security check.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(30)S3 or Release 12.0(31) during the initial boot process.
Note that when the router runs Release 12.0(28)S3 and you boot the router with the SFPs already
installed, the symptom does not occur. However, when you reload the router and then remove and
reinsert the SFPs, they do not pass the security check either.
Workaround: There is no workaround.
CSCsc37404
Symptoms: An Engine 6 line card may reset with the following error messages:
%IPC-5-INVALID: NACK Source Port=0x403F0000
%MCC192-3-CPU_PIF: Error=0x4 %MCC192-3-CPUIF_ERR: Packet Exceeds Programmed Length.
%GSR-3-INTPROC: Process Traceback= 40D32E5C 406D8CE0 ...
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(28)S2.
Workaround: There is no workaround.
CSCsc37572
Symptoms: When you enter the shutdown interface configuration command followed by the no
shutdown interface configuration command on MFR interfaces that are configured on a 1-port
channelized OC-12/STM-4 (DS1/E1) ISE line card, traffic may not longer be forwarded.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(30)S4.
Workaround: Reload the 1-port channelized OC-12/STM-4 (DS1/E1) ISE line card.
Vista de pagina 540
1 2 ... 536 537 538 539 540 541 542 543 544 545 546 ... 677 678

Comentarios a estos manuales

Sin comentarios