
1004
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S
• CSCef28848
Symptoms: The following error message is generated repetitively for an ATM OC-12 line card:
%FIA-3-REQUESTERR: Request error was detected. Type = 1
The output of the show controller fia command shows that the “Empty dst request” field continues
to increment for the line card, and the line card is unable to pass multicast traffic.
Conditions: This symptom is observed on a Cisco 12000 series when multicast packets do not have
their Cisco cell fields properly set.
Workaround: There is no workaround.
• CSCef29467
Symptoms: When you enter commands in various configuration modes such as address-family,
PVC, service-policy, and so on, an invalid input error message may be returned even though the
command was accepted and entered into the running configuration. The following is an example:
Router(config-router-af)#redistribute connected
address-family ipv4 vrf atmTrk
^
Invalid input detected at “^” marker.
Conditions: This symptom is observed on a Cisco 12410 that is configured with two Performance
Route Processors (PRP-1) that function in Route Processor Redundancy (RPR) mode and that runs
one of the following images:
–
The c12kprp-p-mz image of Cisco IOS Release 12.0(24)S3.
–
The c12kprp-p-mz image of Cisco IOS Release 12.0(23)S4.
–
The c12kprp-k3p-mz image of Cisco IOS Release 12.0(27)S2
This list is not all-inclusive: the symptom may also occur in Release 12.0(20)S, Release 12.0(20)ST,
and later releases.
The symptom occurs when the do command is interleaved between configuration commands.
Workaround: Verify that the configuration command is properly accepted by entering the show
running-config command.
• CSCef30166
Symptoms: A Cisco router does not bring down a FR PVC when the interface on the ATM side is
shut down.
Conditions: This symptom is observed on a Cisco router that runs an interim release for Cisco IOS
Release 12.0(30)S only when OAM is configured on the ATM side.
Workaround: There is no workaround.
• CSCef30180
Symptoms: A cell-packing configuration may not be added to a PVC.
Conditions: This symptom is observed when cell packing is configured on an ATM interface.
Workaround: There is no workaround.
• CSCef31649
Symptoms: A VRF interface receives auto-RP discovery packets only once via the core link. After
that, no more RP discovery packets are received. After three minutes, the RP mapping table ages
out, preventing multicast traffic from being passed.
Conditions: This symptom is observed on a Cisco 12000 series that has hardware-enabled multicast
configured on a VRF interface.
Comentarios a estos manuales