Cisco OL-4015-08 Manual de usuario Pagina 454

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 678
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 453
806
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S1
CSCei08381
Symptoms: Engine 3 and Engine 5 line cards in a Cisco 12000 series may fail continuously.
Conditions: This symptom is observed on a Cisco 12000 series that runs a Cisco IOS interim release
for Release 12.0(32)S when control-plane policing is configured on the line cards in the router.
Workaround: There is no workaround.
CSCei08472
Symptoms: The following error message is displayed:
tb2-pe22(config)#pol p1
tb2-pe22(config-pmap)#class match_prec1
tb2-pe22(config-pmap-c)#band per 2
Service-policy is not supported on interface Multilink100.
Conditions: This symptom occurs when a service policy that is attached to a multilink interface with
no members is modified.
Workaround: There is no workaround.
CSCei08823
Symptoms: When a ToFab FCRAM single-bit error (SBE) occurs on an Engine 5 line card, the
following error message is generated, and the line card resets:
Tofab BMA has lost a command
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(31)S and occurs only on an Engine 5 line card.
Workaround: There is no workaround.
CSCei09755
Symptoms: When you remove a multilink bundle by entering the no ppp multilink command under
a serial link configuration, a serial link that is configured in the multilink bundle remains in the “line
protocol down” state and does not recover.
Conditions: This symptom is observed on a Cisco 7600 series that is configured with a SIP1 line
card in which a SPA-CT3 is installed and on a Cisco 12000 series that is configured with a SIP-400
or SIP-600 in which a SPA-CT3 is installed.
Workaround: Reload the SPA by entering the hw-module subslot slot subslot reload command.
CSCei12538
Symptoms: Using the show ssm id command on a line card after a switchover may crash the line
card.
Conditions: This symptom is observed in Cisco IOS Release 12.0(31)S on dual RP platforms that
are running high availability (HA). After a switchover, if the show ssm id command is issued on a
line card, the line card may crash.
Workaround: Do not use the show ssm id on a line card.
CSCei12771
Symptoms: All traffic with a 0 label plus another label is dropped by a 3-port Gigabit Ethernet egress
ISE line card.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(31)S.
Workaround: There is no workaround.
Vista de pagina 453
1 2 ... 449 450 451 452 453 454 455 456 457 458 459 ... 677 678

Comentarios a estos manuales

Sin comentarios