
589
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S6
Field Diag results from eeprom before updating slot 16, run# 0x2 were 0x0
previous field diag eeprom values: run 2 fail mode 0 (PASS)
last test failed was 0, error code 0
Now, notice run# not updated:
f-diag5#diag 16 prev
Field Diag eeprom values: run 2 fail mode 0 (PASS) slot 16
last test failed was 0, error code 0
Then further, the card will not allow a re-test.
f-diag5#diag 16 verbose
Sorry... Field diagnostics already running on requested board
The following cards are likely affected:
73-10474-01 PCA,MBRD,PSC-1,GSR
73-8812-10 PCA,SUB,PRP2,GSR
73-9615-01 PCA,SUB,CSC160-OSP,GSR
73-9718-02 PCA,SUB,ENHANCED CSC160,GSR12810
73-9719-01 PCA,SUB,ENHANCED CSC256,GSR12816
73-9870-03 PCA,SUB,PRP1,GSR
73-9617-01 PCA,SUB,SFC256-OSP,GSR
73-9618-01 PCA,SUB,CSC256-OSP,GSR
This symptom was found as a result of testing for other DDTS related to Field Diags and EEprom
results and related bugs.
Workaround: There is no workaround. An MBUS Agent upgrade is needed.
• CSCsf99087
Symptoms: In using E5 interface as a CE facing interface, when the ce facing interface is enabled
for SNF on output direction, the line card stops forwarding traffic after close to 16k packets have
been punted to CPU for SNF.
Conditions: This symptom has been observed when using an E5 interface as a CE facing interface.
Workaround: Remove the SNF configuration from the CE facing interfaces in output direction.
• CSCsg03826
Symptoms: An OC48E/POS-SR-SC-B linecard is experiencing high CPU and soft drops after a
Cisco IOS upgrade from Cisco IOS Release 12.0(31)S2 to Cisco IOS Release 12.0(32)SY. This is
causing latency in traffic.
Conditions: This symptom has been observed with a
Workaround: There is no workaround.
• CSCsg17957
Symptoms: A router may crash when forwarding an IP fragment.
Conditions: This symptom is observed on a Cisco router that runs Cisco IOS Release 12.2(28)SB3
and that is configured for L2TP and QoS.
Workaround: Remove the QoS configuration. If this is not an option, there is no workaround.
• CSCsg18982
Symptoms: A policy-map with one class that matches on an extended ACL - used for rate-limiting
pings in this case - cannot be applied to an interface on a SIP-600 nor a SIP-601. The following error
message is displayed: "SLOT 0:Oct 2 12:49:34.502 EDT: %EE48-5-TM_PROC: Add Profile Mgr
failure for intf Serial0/0/3.451: 1" This error message is followed by a traceback.
Comentarios a estos manuales