Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 114

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 113
560
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: Occurs if there is a sub-interface on the port facing the portal.
Workaround: There is no workaround.
CSCsz97091
Symptoms: Packet drop occurs when show version, show run, and write memory commands are
issued.
Conditions: Packet drop will be observed as input errors accounted as overruns. The rate of packets
being dropped will be proportional to the rate of traffic.
Workaround: There is no workaround.
CSCsz99027
Symptoms: Router crashes on applying/removing priority from service map.
Conditions:
1. Configure priority in class default. Apply it on EVC on ES20 line card.
2. Remove priority from class default.
3. Now, either removing or applying priority causes the router to crash.
Workaround: There is no workaround.
CSCta00720
Symptoms: Attempting an auto proxy logon causes a crash.
Conditions: This crash is seen only with auto proxy service download.
Workaround: If services are activated by CoA service logon, this issue will not be seen.
Further Problem Description: Attempting authentication of the proxy service causes a crash with
traceback in description when the user profile is similar to:
simulator radius subscriber 1 framed protocol ppp service framed authentication rouble-auto
password cisco vsa cisco 250 Aproxy_service;proxy_user;welcome vsa cisco generic 1 string
"accounting-list=default" !
CSCta04550
Symptoms: Active supervisor may crash if standby supervisor resets for any reason.
Conditions: This can happen if a interface level event happens around the same time of standby
supervisor reload. The timing window is extremely small for the bug to happen.
Workaround: There is no workaround.
CSCta08632
Symptoms: After supervisor forces switchover several times, a router two hops away has wrong ISIS
topology and ISIS routing table.
Conditions:
1. Incremental shortest path first (ISPF) enabled in ISIS.
2. set-overload-bit on-startup in ISIS.
3. Supervisor force switchover several times
Workaround: Disable ISPF in ISIS.
CSCta10442
Symptoms: Policy-map not applied at SIP400 in dLFI over ATM case after performing shut/no shut
of the interface.
Vista de pagina 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 397 398

Comentarios a estos manuales

Sin comentarios