
489
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
3. With traffic on, interface mode is changed as follows:
a. access mode to trunk mode
b. trunk mode to access mode
4. Default the interface with “default int <>” from configuration mode.
5. Router crashes.
Workaround: There is no workaround.
Further Problem Description: Mode changes on switchport with port-security configured from
access mode to trunk mode and then to L3 port by defaulting the interface configuration (with the
default interface interface-number command) in configuration mode can cause the router to crash.
• CSCsv18579
Symptoms: The logging buffer fills with this message:
UTC: FC1: recognized & transferred a satvcl packet, total 604369 UTC: DFC1: recognized &
transferred a satvcl packet, total 604370 UTC: DFC1: recognized & transferred a satvcl packet, total
604371 UTC: DFC1: recognized & transferred a satvcl packet, total 604372 UTC: DFC1:
recognized & transferred a satvcl packet, total 604373
Note: The counter always increments by one.
Conditions: The symptom is observed with Cisco IOS Release 12.2(18)SXF5 and when reflexive
ACL is configured.
Workaround: There is no workaround.
• CSCsv49924
Symptoms: The wrong binding and route are created on the DHCP Relay Agent.
Conditions: The symptom is observed when multiple DHCP Relay Agents are present in between
clients and the DHCP server.
Workaround: There is no workaround.
• CSCsv66694
Symptoms: If the router has a static route and that route is redistributed into EIGRP with a
route-map, the EIGRP topology table shows that the router is setting the tag on the redistributed
route. However, both the routing table and the EIGRP topology table do not show the tag as being
set.
Conditions: The symptom is observed when a Cisco ASR 1006 router that is running Cisco IOS
Release 12.2(33)XNB1 is EIGRP neighbors with a Cisco 7300 series router (running Cisco IOS
Release 12.2(31)SB10).
Workaround: There is no workaround.
• CSCsv81952
Symptoms: Standby supervisor reloads due to parser return code error.
Conditions: The symptom is observed when the redundant supervisor is running Cisco IOS
Release 12.2(33)SRD3.
Workaround: There is no workaround.
Further Problem Description: The issue can be seen, for example, by creating parser view (it was
also reported when removing service policy from ATM subinterface):
Router#conf t
Comentarios a estos manuales