
466
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: See the following sample show output when this happens:
PE1#sh atm pvc 11/900
ATM3/0/0: VCD: 4095, VPI: 11, VCI: 900
UBR, PeakRate: 149760 (353208 cps)
AAL5 L2transport, etype:0x1B, Flags: 0x1861, VCmode: 0x0, Encapsize: 4
OAM Cell Emulation: not configured
Interworking Method: like to like
AC Type: ATM AAL5, Circuit Id: -2146761852<<, AC State: UP, Prov: YES
Switch Hdl: 0x1FF7FFB, Segment hdl: 0x3FEDFF6
AC Hdl: 0xC7010FE0, AC Peer Hdl: 0xF4010FE1, Flg:0, Platform Idx:4093
Remote Circuit Status = No Alarm, Alarm Type = None
Local Circuit Status = No Alarm, Alarm Type = None
InPkts: 0, OutPkts: 0, InBytes: 0, OutBytes: 0
InPRoc: 0, OutPRoc: 0, Broadcasts: 0
InFast: 0, OutFast: 0, InAS: 0, OutAS: 0
InPktDrops: 0, OutPktDrops: 0
CrcErrors: 0, SarTimeOuts: 0, OverSizedSDUs: 0, LengthViolation: 0,
CPIErrors: 0
Out CLP=1 Pkts: 0
OAM cells received: 0
F5 InEndloop: 0, F5 InSegloop: 0, F5 InAIS: 0, F5 InRDI: 0
OAM cells sent: 0
F5 OutEndloop: 0, F5 OutSegloop: 0, F5 OutAIS: 0, F5 OutRDI: 0
OAM cell drops: 0
Status: UP
Workaround: There is no workaround.
• CSCte49283
Symptoms: Sometimes the LNS router sends an incorrect NAS-Port value.
Conditions: The symptom is observed when the LNS router sends a stop accounting-request to the
RADIUS server.
Workaround: There is no workaround.
• CSCte49641
Symptoms: On ES+, policy map is attached to subinterface on main or port- channel. Traffic is not
being marked with CoS value specified in the policy map, and it is always propagated from
dscp/precedence of the packet.
Conditions: This symptom is seen when attaching CoS marking policy map to subinterface on main
or port-channel of ES+ LC, Cisco 7600 router, enable the mls qos command. Traffic is not being
marked with CoS value specified in the policy map, and it is always propagated from
DSCP/precedence of the packet.
Workaround: There is no workaround.
Further Problem Description: On routed interfaces, ES+ mark the packet as “trust dscp” even when
ingress marking of CoS is configured (“set cos 0-7”) in the policy map. Because of this, CoS value
is always propagated from dscp/prec.
• CSCte74705
Symptoms: A Cisco 7600 router that is running Cisco IOS Release 12.2(33)SRD may generate L2
Queue Error (%L2-SP-4-QUEER) messages when a link down/up event occurs across multiple
interfaces in a short period of time.
Conditions: This symptom may occur when a large number of attachment circuits are configured
with EVC style configuration, and a large number of MAC addresses are known to the system.
Workaround: There is no workaround.
Comentarios a estos manuales