
807
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Customers are advised to upgrade to the newer image with this new initialization sequence. Newer
software will be backward compatible with older SPA boards.
• CSCso95426
Symptoms: In each retransmit, the AAA client explicitly shows the radius-key in the debug output,
causing security concerns.
Conditions: Occurs when RADIUS debugs are enabled, such as debug radius all.
Workaround: There is no workaround. However, this is not know to impact functionality.
• CSCso97318
Symptoms: PPPoE over VLAN over ATM functionality is broken
Conditions: This is resulting in both PPPoE client (Cisco PPPoE test driver) and PPPoE server
caching wrong PPPoE encapsulation string (with double VLAN tag). LCP CONF request from each
side is not properly processed by the peer, so the session never comes up.
Workaround: There is no workaround.
• CSCso97593
Symptoms: Cisco ASR1000 loses QoS configuration after reload.
Conditions: Cisco ASR1000 will lose the configuration if flat service policy is configured on
Multilink Point-to-Point Protocol (MLPPP) bundles.
Workaround: This problem is not seen if MLPPP bundles are configured with hierarchical service
policy.
• CSCso97695
Symptoms: Config replace used to fail with TFTP.
Conditions: No special conditions.
Workaround: TFTP copy worked fine. The workaround is to copy it and then do a config replace
from the disk.
• CSCso98143
Symptoms: At boot up router may crash with the following error messages:
%IPC-2-ONINT: Invalid operation at interrupt level: IPC blocking send request
icc_send_request_internal: ipc_send_rpc_blocked failed, result 8
Conditions: Occurs on Cisco 7600 configured with VRF-Lite aware PBR route-maps and running
Cisco IOS Release 12.2SR or Cisco IOS Release 12.2SRC.
Workaround: There is no workaround.
• CSCso98964
Symptoms: EIGRP authentication with a key string longer than 16 characters may fail. EIGRP
neighbors will fail to establish.
Conditions: Occurs in routers running a variety of Cisco IOS Release 12.2 versions.
Workaround: Use a shorter key string.
• CSCso99860
Symptoms: Some of the initially shipped PWR-1500-DC power supplies in Cisco 7603S chassis
have incorrect SNMP OID programmed in the IDProm. The vendorOID does not match with the
CANA-assigned number in CISCO-ENTITY-VENDORTYPE-OID-MIB.my
Conditions: This is applicable for those power supplies for which the vendorOID is programmed as
193 and not as 194.
Comentarios a estos manuales