Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 341

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 340
787
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: The goal of the test is to verify the successful termination of PPP/PPPoE over ATM
sessions on router’s ATM interface using auto sensing. It is performed with auth_pap, process
switch, and keepalive disabled. This has a functional impact as the virtual access entry is not getting
added to the routing table after doing clear ip route.
Workaround: There is no workaround.
CSCso30598
Symptoms: If GLBP is configured on the native Gigabit Ethernet interface of a Cisco 7300, the
router will continually reload if an HA switchover is performed.
Conditions: This problem affects only the native Gigabit Ethernet interface of a Cisco 7300 because
this hardware does not support HA.
Workaround: There is no workaround.
CSCso30669
Symptoms: The standby RP continuously reloads after showing the following error message:
HA-6-INT_SSO_UNAWARE
Conditions: The symptoms are observed only when a Virtual Router Redundancy Protocol (VRRP)
group is configured on one of the RP native GE-interfaces on a Cisco 7304 router (which does not
currently support SSO).
Workaround: VRRP can be configured on the Gigabit Ethernet Shared Port Adapter (SPA) interfaces
on this platform, which are fully SSO-aware.
CSCso30819
Symptoms: Occasionally upstream traffic may be dropped when a private VLAN is configured, and
after an OIR or the shutdown followed by the no shutdown commands are used.
Conditions: The symptom is observed after sending untagged upstream traffic using the
secondary/isolated VLAN from the promiscuous port. After using the shutdown and no shutdown
command sequence (or an OIR), traffic may get dropped due to CBL logic being in the improper
state.
Workaround: Reload the system.
CSCso30946
Symptoms: Line card does not come up first time with image download failure with the following
error message:
%ONLINE-SP-6-DNLDFAIL: Module <slot>, Proc. 0, Runtime image download failed because
of scp send failure
Conditions: This is mainly seen when multiple line cards removed and inserted at the same time.
Workaround: There is no workaround.
CSCso32982
Symptoms: NSE-100 processor crashes while bringing up L2TPV3oATM-FR circuit.
Conditions: It occurs consistently when we bring up L2TPV3oATM-FR.
Workaround: There is no workaround.
CSCso33003
Symptoms: If a child policy is attached to a parent policy twice, the router will reload if child policy
configuration is removed.
Conditions: The parent policy needs to be attached to target interface.
Vista de pagina 340
1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 397 398

Comentarios a estos manuales

Sin comentarios