Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 169

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 168
615
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: Consider removing MPLS netflow configuration by removing the ip flow-cache mpls
label-postion 1 command.
CSCsw76113
Symptoms: Unable to reuse a sub-interface as main-interface.
Conditions: Occurs when we configure no virtual-template subinterface when all of the Interface
Descriptor Blocks (IDB) that platform supports are used as “subif-vaccess”. No more “vaccess” can
be created.
Workaround: Do not configure no virtual-template subinterface at run time. Check show
vtemplate output. If there are more IDBs used by subinterface, then do not configure no
virtual-template subinterface.
CSCsw76910
Symptoms: Supervisor reloads on configuring or verifying firewall farm commands.
Conditions: Occurs before and after compliance testing on the firewall farm commands.
Workaround: There is no workaround.
CSCsw77205
Symptoms: ES20 line cards crashing in a loop while using a anything over MPLS (AToM) VC with
Cisco Intelligent Services Gateway (ISG).
Conditions: The issue is seen on all the ES20 cards installed in a Cisco 7609 router running Cisco
IOS Release 12.2(33)SRC2.
Workaround: Manually shutdown the AToM interfaces and ISG interfaces to stop the crashes.
CSCsw78413
Symptoms: The BFD configuration may be lost from the interface/sub-interface upon a router reload
or physical module of OIR.
Conditions: The symptom is seen when BFD is configured on an interface in certain multi-slot
chassis.
Workaround: Ethernet interfaces seem immune to this problem. Certain platforms, such as the Cisco
10000 series router, are also immune.
CSCsw78939
Symptoms: No new sessions can come up using VPDN after a few days.
Conditions: The root cause is that we leak and run out of SSM switch IDs.
Workaround: There is no workaround.
CSCsw81485
Symptoms: Issuing no form of IPX configuration commands on an interface crashes the switch.
Conditions: Occurs when IPX routing is enabled on the device but not on the interface.
Workaround: Do not issue no form of IPX configuration commands on an interface where IPX is
not enabled.
CSCsw82462
Symptoms: A connected prefix from the global routing table has a VPN routing/forwarding (VRF)
interface as outgoing interface.
Conditions: This condition occurs after a clear ip route x.x.x.x for the prefix x.x.x.x.
Vista de pagina 168
1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 397 398

Comentarios a estos manuales

Sin comentarios