Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 248

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 247
694
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: There is no workaround.
CSCsj12867
Symptoms: The following message can be seen after executing the write memory command, even
though the version has not been changed.
Router# write memory
Warning: Attempting to overwrite an NVRAM configuration previously written by a different
version of the system image. Overwrite the previous NVRAM configuration?[confirm]
The router then restarts with the following traceback:
-Traceback= 6067F3DC 6067FB38 605E3FE8 60686384 605E3FE8 605188BC 60518830 605444D4
60539164 6054719C 605AB65C 605AB648
Conditions: This symptom is observed on a Cisco 7206 VXR (NPE-400) with
C7200-IO-FE-MII/RJ45= or C7200-I/O=.
Workaround: There is no workaround.
CSCsj19019
Symptoms: WWCP, when used in GRE mode, Netflow entries are not installed.
Conditions: This is seen in modular Cisco IOS images.
Workaround: There is no workaround.
CSCsj35342
Symptoms: When AAA gigabyte counter support is enabled, it is possible for the AAA HC Counter
process to consume significant CPU.
Conditions: This symptom occurs when AAA gigabyte counter support is enabled.
Workaround: Configure "no aaa accounting gigawords."
CSCsj49293
Symptoms: The interface output rate (214 Mb/s) is greater than the interface line rate (155 Mb/s).
Conditions: This symptom is observed with a Cisco 7600/7500/7200-NPE400 and below. That is,
PA-POS-2OC3/1OC3 (PULL mode).
Workaround: There is no workaround.
Further Problem Description: From the Ixia, packets are transmitted at 320 Mb/s. On the UUT
(Cisco 7600), the outgoing interface (POS-Enhanced Flexwan) shows the output rate as 200 Mb/s.
But the interface bandwidth is 155 Mb/s.
CSCsj56281
Symptoms: Inherit peer-policy does not work after router reload.
Workaround: There is no workaround.
CSCsj57351
Symptoms: Router Crashes if a invalid EVC name is configured.
Conditions: Occurs when "debug ethernet service instance error" is enabled.
Workaround: If ether-infra debugs are enabled, then always configured a valid EVC name and attach
it to service instance. Do not enable the "debug ethernet service instance error".
CSCsj58223
Symptoms: Crash due to a bus error after the show memory command is entered.
Vista de pagina 247
1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 397 398

Comentarios a estos manuales

Sin comentarios