
736
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
• CSCsl86633
Symptoms: SCHED-2-EDISMSCRIT: Critical/high priority process rf_cc_clear_counter_process
may not dismiss message seen on supervisor switchover with SSO operating mode.
Conditions: This message can be seen if port-channel configuration exists on the Cisco 7600. There
is no known impact because of this message.
Workaround: There is no workaround.
• CSCsl87404
Symptoms: L2TP tunnels are not getting established.
Conditions: Occurs on a router running Cisco IOS Release 12.4(15)T2.
Workaround: There is no workaround.
• CSCsl87843
Symptoms: When changing the IP/IPv6 address of the interface, the Gateway Load Balancing
Protocol (GLBP) operating on this router temporarily flaps to another GLBP group member.
Conditions: The problem only occurs when the new IP/IPv6 address is lower than the existing
address. The problem does not occur if it is higher. There must be more than one GLBP router in the
group.
Workaround: Do not change the IP/IPv6 address of the interface while the current router is actively
operating as a member of a GLBP group.
• CSCsl87935
Symptoms: Memory leak in SSS. SSS info element and SSS info list.
Conditions: QoS fails being deleted from the session and reports the failure to Session Manager
(SM). Session Manager finishes cleaning up the session.
Workaround: There is no workaround.
Further Problem Description: When the TC feature is being deleted, it will send this
SSS_INFOTYPE_SERVICE_REMOVED_KEY element key to SM in a notify event. By this time,
SM has finished clearing this session and therefore cannot locate the SM context. SM will, in turn,
display an error message:
Jan 17 09:28:31.816: SSS MGR: Bad Handle in Feature Msg, ID = 0x37000002
and return without cleaning up both message and any transient data within the message.
• CSCsl88931
Symptoms: When a SPA-SER-4XT is being used, the following error message is seen:
%SERIAL_12IN1-3-SPI4_HW_ERR: SPA 4/3: Port0 SNK SPI4 DIP4 Error was encountered.
Conditions: A SPA-SER-4XT should be present in a MCP platform to hit this problem.
Workaround: There is no workaround.
Further Problem Description: Apart from the above error message the SPA functions normally and
packet continue to pass through
• CSCsl89176
Symptoms: Router crashes while polling for VLAN information.
Conditions: This happens in all platforms where the device is polling for vlan information using
vlanTrunkPortEntry via SNMP.
Comentarios a estos manuales