Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 177

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 176
623
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
CSCsx40675
Symptoms: Router crashes
Conditions: Occurs during xconnect L2TP session configuration.
Workaround: There is no workaround.
CSCsx40747
Symptoms: A specific configuration of “ip casa” followed by a subsequent use of the command
show running-config can cause the router to go into an infinite loop and hang.
Conditions: The symptom is observed when “ip casa” is configured and you enter into config-casa
mode. The command show running-config will cause the router to hang.
Workaround: There is no workaround.
Further Problem Description: This issue is specific to the usage of ip casa. If you do not use casa,
you are not vulnerable to the issue described here.
CSCsx41877
Symptoms: ATM PVP CLI become inaccessible to the command-line interface.
Conditions: The commands disappear after configuring l2transport VCs on ATM interface.
Workaround: Execute default on ATM interface before configuring any L2VC or L2VP.
CSCsx43897
Symptoms: CPU utilization goes high when a third session is allowed to be created through SNMP.
Also occurs with applications that use SNMP to create sessions, such as NAM GUI.
Conditions: Perform the SNMPSet on the service module session (this will fail). Now try to create
another local session via SNMPSets sequence.
Workaround: Use CLI to create the sessions.
CSCsx46858
Symptoms: Router crashes while configuring MAC addresses.
Conditions: Occurs when configuring MAC addresses under VT interface in “config-rite” mode.
Workaround: There is no workaround.
CSCsx47554
Symptoms: With a topology like this:
CE | type 4 xconnect type 4 xconnect |-------------------- 7600 --------------- GSR
-------------- CE SIP400 Sup720 Giga subif Giga subif
the packets above 1496 are not passing through end-to-end.
The MTU on the edge-facing interfaces is 1500, the one on the core-facing interfaces is 1600.
Conditions: The GSR on the other side seems not to have a similar behavior. The bug has been
reproduced in Cisco IOS Release 12.2(33)SRB3 and SRC3.
Workaround: Increase the MTU on the edge-facing interface end-to-end
CSCsx56369
Symptoms: Connectivity breaks on SPA based multilink bundles with ACFC/PFC configured when
one of the member links go down.
Conditions: Occurs on a Cisco 7600. Multilink must be SPA based with ACFC/PFC configured. The
output of show ppp multilink on the RP would show multilink in hardware.
Workaround: Adding back the link or bringing the link back up makes it work.
Vista de pagina 176
1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 397 398

Comentarios a estos manuales

Sin comentarios