Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 63

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 62
509
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
238-241
494-497
750-753
1006-1009
1262-1265
The following error will be reported when the packets are dropped:
%DEV_SELENE-DFC3-3-XAUI_LEN: Selene 0 XAUI 0 Packet Length Error
Conditions: The symptom is observed on a Cisco 7600 series router that is running Cisco IOS
Release 12.2(33)SRD2, using an interface on a 7600-ES+40G3CXL module for a core-facing
L2TPv3 tunnel.
Workaround: Disable L2TPv3 cookies.
CSCtc36588
Symptoms: After reload in Cisco IOS Release 12.2(33)SRD3, the MAC address of a port-channel,
including member links on the supervisor, is set to 0000.0000.0000.
Conditions: This issue is seen after a reload in Cisco IOS Release 12.2(33)SRD3 and when a
port-channel has member links on the supervisor.
Workaround: Configure the MAC address as follows:
7600(config)#interface port-channel XY
7600(config-if)#mac-address XXXX.YYYY.ZZZZ
CSCtc37147
Symptoms: RPF check fails when default route originates from IS-IS and the egress interface is a
TE tunnel.
Conditions: This symptom is observed when IS-IS is configured as the routing protocol and the
default route originates from IS-IS.
Workaround: Use the ip mroute command or route-leaking to set a specific route in the table. Enter
show ip route 0.0.0.0 to determine if the next hop for the default route is an MPLS tunnel interface.
If it is, enter ip mroute to configure the real interface that the MPLS TE tunnel uses for the default
route multicast nexthop.
Alternate workaround: Use the OSPF routing protocol rather than IS-IS.
CSCtc38796
Symptoms: In some instances, when the Cisco 7600/RSP720/RP crashed and the core dump is
configured to be created. But this coredump is corrupted and recognized by gdb.
Conditions: This symptom is seen only with RSP720.
Workaround: There is no workaround.
CSCtc40677
Symptoms: The distribute-list applied to the virtual-template interface is not effective for the
virtual-access interfaces spawned by that template. For example, configured on the ASR (hub) is:
router eigrp 1
redistribute static metric 10000 100 255 1 1500
network 10.0.0.0
no auto-summary
Vista de pagina 62
1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 397 398

Comentarios a estos manuales

Sin comentarios