
750
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
• CSCsm23560
Symptoms: OSPF TE tunnel does not replace the existing route, which can be verified using the
show ip route command.
Conditions: The symptom is observed when using the mpls traffic-eng multicast-intact command
so that PIM and MPLS-TE can work together in OSPF. The tunnel route will be established but it
will not replace the existing ethernet route.
Workaround: Use the clear ip ospf process.
Alternate workaround: Do not use the mpls traffic-eng multicast- intact command, so that PIM
and MPLS-TE do not work together and OSPF tunnel is able to replace the route.
• CSCsm23764
Symptoms: A device keeps reloading every 50 minutes.
Conditions: The issue will occur only if the standby RP gets reloaded while CEF is part-way through
synching initial data to the standby RP before standby hot state is reached in SSO mode.
Trigger: Removal or reload of standby before CEF initial synch is complete.
Impact: This issue affects operations.
Workaround: Reload the active PRE if this issue occurs.
• CSCsm25854
Symptoms: Dropped packets are not being counted for DLFI interfaces.
Conditions: Occurs when DLFI is configured over Frame Relay, and policy map is attached to
virtual template.
Workaround: There is no workaround.
• CSCsm26130
Symptoms: When removing a subinterface from the configuration that contains an IP address that
falls into the major net of the static route, the static route is no longer injected into the BGP table.
Since the route is not in the BGP table, it is not advertised to any peers.
Conditions: This symptom is observed with auto-summary enabled in BGP. A static summary route
is configured to null0 and is injected into the BGP table with a network statement.
Workaround: There are four possible workarounds:
1) Use an "aggregate-address" configuration instead of the static route to generate the summary. 2)
Remove auto-summary from the BGP process. 3) Enter the clear ip /jointfilesconvert/422273/bgp * command. 4) Remove
and reconfigure the BGP network statement for the summary route.
• CSCsm26150
Symptoms: Router crashes while configured for Circuit Emulation over Packet (CEoP) SPA.
Conditions: Issue is reproducible through script run (one of every 3 to 4 times).
Workaround: There is no workaround.
• CSCsm26610
Symptoms: A router running Cisco IOS may unexpectedly reload.
Conditions: This is specific to platforms with powerpc processors, such as the npe-g2 and 2600xm
series routers. It requires either the legacy rate-limit config or MQC style policer configured on an
interface.
Workaround: There is no workaround.
Comentarios a estos manuales