Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 151

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 150
597
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Symptoms: Cisco router crashes when Open Shortest Path First (OSPF) neighbor is being
configured in non-base topology and IP address of the neighbor does not fall into range of any
existing interface.
Conditions: This crash will only occur when OSPF is configured to support multi-topology routing,
and neighbor statements are used in the submode for a non-base topology.
Workaround: Configure the neighbor with this IP address in the base topology first.
CSCsv00168
Symptoms: Junk values are being displayed on the router when characters/commands are inputted.
For example, enter “enable”, it shows “na^@^@”; enter “show version”, it shows “h
^v^@e^@^r^@^@^@^@^@”.
Conditions: The symptoms are observed with Cisco IOS Release 12.4(23.2)T.
Workaround: There is no workaround.
Further Problem Description: The CLI function is not affected by the junk values.
CSCsv01474
Symptoms: The ip rip advertise command might be lost from the interface.
Conditions: This symptom occurs in any of the following three cases:
1. The interface flaps. 2. The clear ip route command is issued. 3. The no network <prefix>
command and then the network <prefix> command are issued for the network corresponding to the
interface.
Workaround: Configure the timers basic command under the address-family under rip.
CSCsv02117
Symptoms: The following system error message with “Out of IDs!” warning is seen with traceback:
%IDMGR-3-INVALID_ID: bad id in id_get (Out of IDs!) (id: 0x0)
Conditions: This symptom is observed when flapping 24K sessions over 12K tunnel once, recreating
this issue.
Workaround: There is no workaround.
CSCsv03300
Symptoms: Cisco 7200 NPEG2 router crashes while displaying the interface output for onboard
gigabit ethernet using the show interface gig0/x command.
Conditions: Occurs when a CBWFQ QoS policy is attached to the onboard gigabitethernet interface.
Workaround: There is no workaround.
CSCsv04674
Symptoms: The M(andatory)-Bit is not set in Random Vector AVP, which is a must according to
RFC2661.
Conditions: This symptom is observed with Egress ICCN packet with Random Vector AVP during
session establishment.
Workaround: There is no workaround.
CSCsv04733
Symptoms: A LAC might terminate a tunnel unexpectedly.
Conditions: This symptom is seen when the tunnel password exceeds 31 characters.
Workaround: Use a shorter password if policy allows.
Vista de pagina 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 397 398

Comentarios a estos manuales

Sin comentarios