Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 324

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 323
770
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: There is no workaround.
Further Problem Description: The crash may occur when an event triggers access to a previously set
up AToM VC. For example, the crash may occur when fast reroute (FRR) is configured on the tunnel
interface and the primary interface is removed, such as in the following scenario:
pseudowire-class ER1_to_HR1_EoMPLS no preferred-path interface Tunnel501331
disable-fallback ! interface tunnel501331 shutdown ! no interface tunnel501331
CSCsm73602
Symptoms: High CPU load due to VTEMPLATE Backgr process.
Conditions: Occurs when ip multicast boundary command is used on many interfaces (8000 or
more).
Workaround: There is no workaround.
CSCsm74143
Symptoms: INTR_MGR-DFC7-3-BURST: msg seen when PMAP is removed from subinterface.
Conditions: Occurs on a ES20 LC with subinterface having a HQoS policy applied. The steps are:
1) Remove the child policy from the parent class.
2) Remove the service-policy from the subinterface.
Workaround: Apply the service-policy again in the interface and remove the policy.
CSCsm74961
Symptoms: The standby RP cannot synchronize with the active RP subscriber session status. The
active RP shows the session is TAL(MAC+Opt82) authenticated and up, but the standby RP shows
no active sessions.
Conditions: Cisco 7600 configured as follows:
*Initiator: IPoQ/DHCP
*IP Address Assignment: Radius class name, ISG-DHCP Relay
*Authorization: TAL (MAC+Opt82)
*Network Service: VRF Mapping
*Accounting: Postpaid
*QoS: Session MQC
*Service/features: Security ACL, ARP Ping, Open Garden
Workaround: There is no workaround.
CSCsm76792
Symptoms: A standby supervisor power cycles over and over on boot up. The following errors are
seen:
May 14 19:21:09.188 EDT: %RF-SP-3-NOTIF_TMO: Notification timer Expired for RF Client:
Cat6k Power(1318)
Conditions: This has been experienced on a Catalyst 6500 with dual supervisors running Cisco IOS
Release 12.2(33)SXH2a and Cisco IOS Release 12.2(33)SXH3.
Workaround: There is no workaround.
CSCsm76857
Symptom: Adjacency turns incomplete when the same mac-address or different mac-address is
reconfigured/configured under ATM interface. Packets go through but may be getting process
switched.
Vista de pagina 323
1 2 ... 319 320 321 322 323 324 325 326 327 328 329 ... 397 398

Comentarios a estos manuales

Sin comentarios