Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 359

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 358
805
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: Disable NetFlow. This is done with the following commands:
no ip flow ingress no ip flow egress no ip route-cache flow
Enter the appropriate command for each subinterface for which NetFlow is currently configured.
CSCso87838
Symptoms: Switch may report flapping HSRP peers when the wr mem command is issued.
Conditions: The symptom is observed when HSRP is configured with aggressive timers and the wr
mem command is issued.
Workaround: Increase the timer values for HSRP or consider not using aggressive timers.
CSCso87916
Symptoms: Router may crash when booting with large number of interfaces configured for RIP for
IPv6 (RIPng).
Conditions: Occurs when RIPng is configured on 1000 or more interfaces.
Workaround: There is no workaround.
CSCso88718
Symptoms: Sessions come up on LNS even after the associated VT on the LAC has been removed.
Conditions: This symptom is seen when the BBA group should have virtual- template configured in
it even after deleting the virtual-template interface.
Workaround: Remove virtual-template configuration from the BBA group.
CSCso88898
Symptoms: The line card displays memory allocation failure messages, and memory statistics
indicate a continuous decline in free memory.
Conditions: When port mode or VC mode cell relay configuration is applied on an ATM interface,
it is observed that after traffic switching for a long time (approximately 48 hours, depending on
scale), the above problem occurs.
Workaround: There is no workaround.
CSCso89464
Symptoms: Command is rejected with the following error message
" interface range invalid, max 1000 interfaces allowed - command rejected".
Conditions: Occurs during the following sequence: Router (config)# interface range create vlan
100 interface range invalid, max 1000 interfaces allowed - command rejected
Workaround: There is no workaround.
CSCso89794
Symptoms: Spurious accesses are seen when SNMP queries are performed on the router.
Conditions: This symptom occurs if SNMP queries like "snmpwalk -v2c 7.42.19.43 public
.1.3.6.1.4.1.9.3.6.13.1" are performed on the router. Spurious accesses are seen.
Workaround: There is no workaround.
CSCso90021
Symptoms: If there is a port-channel configured with members from both bays and EVCs are
configured on that port channel with BD, removing then adding the EVCs may then cause some of
them to fail to send traffic.
Vista de pagina 358
1 2 ... 354 355 356 357 358 359 360 361 362 363 364 ... 397 398

Comentarios a estos manuales

Sin comentarios