Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 146

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 145
592
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Symptoms: Router may crash when “show tracking brief” is entered if one or more tracking object
have been created using the Hot Standby Routing Protocol (HSRP) cli, such as standby 1 track
Ethernet1/0.
Conditions: This does not occur if all tracking objects use the new track command as follows:
track 1 interface Ethernet1/0 line-protocol interface Ethernet 0/0 standby 1 track 1
Workaround: Use show tracking instead, or configure tracking with the new command.
CSCsu67637
Symptoms: IPv6 address of loopback interface set as passive under Intermediate
System-to-Intermediate System (IS-IS) router process is not present in IS-IS database.
Conditions: Issue is seen when loopback interface is set as passive under router IS-IS configuration
and the IPv6 address of the interface is only added afterwards. If the passive-interface command is
used when the loopback interface already has its IPv6 address configured, issue is not seen.
Workaround: After the IPv6 address is configured under the affected interface, remove and add the
passive-interface configuration under the router IS-IS process.
CSCsu69590
Symptoms: After Flex Link failover, connectivity may be lost. Configured VLANs might be pruned
on active link, causing VLAN interface to go down.
Conditions: This usually happens after the second Flex Link failover.
Workaround: Remove the Flex Link configuration from the interface, then reconfigure it.
CSCsu71004
Symptoms: Cisco 7600 RP crashes while executing the copy tftp sup-bootdisk: command. A
similar crash seen upon switchover
Conditions: Occurs when issuing a copy command from SP console on an RSP720.
Workaround: There is no workaround.
CSCsu71728
Symptoms: A crash may occur while applying QOS under an MFR interface.
Conditions: The symptoms are observed while applying QOS under an MFR interface on a
PA-MC-2T3-EC i n L 2 V PN .
Workaround: There is no workaround.
CSCsu72025
Symptoms: SIP400 may crash during Change of Authorization (CoA) push.
Conditions: Occurs on a SIP400 with ACL configurations on iEdge sessions and CoA push enabled.
Workaround: There is no workaround.
CSCsu73128
Symptoms: Router crashes.
Conditions: Occurs when large number of remote end points try to connect to the gateway at the
same time. The router may crash if “rsa-sig” is used as authentication method.
Workaround: There is no workaround.
CSCsu74397
Vista de pagina 145
1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 397 398

Comentarios a estos manuales

Sin comentarios