
531
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: This issue can be seen with the following conditions:
1. Issuing show tech command on ES+
2. Issuing show platform hardware config-pld command on ES+
Workaround: Do not use show tech and show platform hardware config-pld commands on ES+.
Resolved Caveats—Cisco IOS Release 12.2(33)SRD3
Cisco IOS Release 12.2(33)SRD3 is a rebuild release for Cisco IOS Release 12.2(33)SRD. The caveats
in this section are resolved in Cisco IOS Release 12.2(33)SRD3 but may be open in previous Cisco IOS
releases.
• CSCee63182
Symptoms: A Cisco router may crash or may stop responding.
Conditions: This has been always seen with an atm interface only when a rate-limit command is
enabled on the interface. The crash occurs when an interface that is configured with a rate-limit
command is deleted by entering the no interface command and then reenabled by entering the
interface command.
Workaround: Remove the rate-limit configuration from the interface before deleting the interface.
Further Problem Description: Happens under very specific circumstances and the crash is seen
randomly.
• CSCse15495
Symptoms: The following CLASS-BASED-QOS-MIB counters are incorrect in output direction:
- cbQosCMPrePolicyByte64
- cbQosCMPostPolicyByte64
In input direction cbQosCMDropByte64 is incremented and is always equal to
cbQosCMPrePolicyByte64.
Conditions: Hardware specific setup: SIP-600 and 10GE SPA.
Workaround: There is no workaround.
• CSCse29527
Symptoms: A Cisco 7600 Series router or Cisco Catalyst 6500 Switch may unexpectedly reload due
to bus error when running remote command switch show mmls met.
Conditions: Occurs when the device is doing multicast.
Workaround: Do not run the command.
• CSCse97873
Symptoms: Resilient Ethernet Protocol (REP) flaps due to excessive CPU utilization occurs.
Conditions: Occurs in a Resilient Ethernet Protocol (REP) segment if 4000 VLANs are configured
on the router and if VLANs are allowed on a switchport.
Workaround: There is no workaround.
• CSCse99958
Symptoms: A Cisco router may fail to access a flash card after formatting it, and the following error
message is generated:
*** Emulating mis-aligned load at 0x80000190 PC = 0x8001179c ... succeeded
Comentarios a estos manuales