Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 127

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 126
573
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Workaround: There is no workaround.
CSCso29361
Symptoms: The commands given in the interface range command may not be synced to all
interfaces configured in the range in the standby supervisor.
Conditions: Occurs when configuration commands are entered under interface vlan range
command. They get attached to only the first VLAN in the range in the redundant supervisor. After
switchover, traffic does not flow due to the missing VLAN configuration.
Workaround: There is no workaround.
CSCso42170
Symptoms: CPUHOG and traceback messages seen for IP NAT ager process.
Conditions: Occurs when NAT is configured with dynamic translations greater than 27,000, and the
NAT pool is exhausted. The following messages are seen:
05:13:43: %SYS-3-CPUHOG: Task is running for (2000)msecs, more than (2000)msecs
(19/13),process = IP NAT Ager. -Traceback= 40BA0994 40BA0F00 40B983A8 40B9852C
413C2B08 413C2AF4
Workaround: There is no workaround.
CSCso56038
Symptoms: The following error message may be seen:
%DUAL-3-INTERNAL: eigrp 4: Internal Error
Conditions: This symptom is seen when a PE-CE setup using site-of-origin (SoO) tags, in which an
PE router that is running EIGRP can learn the same route both by EIGRP (from a CE neighbor) and
also by redistribution.
The above error may be seen when EIGRP on the PE prepares to send information to a neighbor
about a route learned from another neighbor (with no SoO tag), but before the information can be
sent, the route is replaced by a redistributed route (with an SoO tag). The above error can be seen.
This behavior is very dependent on the timing of this series of events.
Workaround: There is no workaround.
Further Problem Description: It is not clear what functional impact this may have, or whether the
error message is purely a warning.
CSCso57020
Symptoms: Etherchannel states for Link Aggregate Control Protocol (LACP) port-channels are
inconsistent between active and standby, which could possibly affect traffic forwarding.
Conditions: Occurs while configuring several LACP port channels. This could be seen if LACP port
channels are configured and the device is brought up in SSO mode.
Workaround: Once the standby is completely up in HOT state, perform a shut/no shut on the
interfaces that are inconsistent.
CSCso65266
Symptoms: A customer upgraded to Cisco IOS Release 12.0(32)Sy4, and now the customer is seeing
a memory leak in the BGP process. The memory leak is happening with the BGP router process at
the rcach chunk memory when the route map has a “continue” clause in the configuration.
Conditions: The leak is seen when a “continue” statement is configured in a inbound/outbound route
map.
Workaround: There is no workaround.
Vista de pagina 126
1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 397 398

Comentarios a estos manuales

Sin comentarios