
832
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: Occurs when multicast RP is configured under VPN routing/forwarding (VRF) first.
When the VRF is deleted, some multicast data may still be locked and not deleted, causing the
traceback when a new VRF is created and multicast RP is configured there.
Workaround: There is no workaround.
• CSCsr19860
Symptoms: The standby may reload when upgrading the software from Cisco IOS Release
12.2(31)SB to Cisco IOS Release 12.2(33)SB1.
Conditions: This symptom occurs at run version during client verification.
Workaround: There is no workaround.
• CSCsr20566
Symptoms: A router may log SCHED-3-STUCKMTMR for Dampening process, after which point
all dampened interfaces will be permanently dampened from a routing-protocol viewpoint.
Conditions: This symptom is observed when multiple interfaces are configured with dampening
feature.
Workaround: There is no workaround.
• CSCsr22594
Symptoms: Bindings assigned by the On-Demand Address Pool (ODAP) pool not synced with the
standby.
Conditions: Occurs with a Cisco 10000 as the ODAP device. Bindings of the ODAP pool are not
synced with the standby.
Workaround: There is no workaround.
• CSCsr25168
Symptoms: Router crashes while configuring destination interface range other than available
interface.
Conditions: Configure a monitor session with destination interface range other than available
interface.
Workaround: There is no workaround.
• CSCsr27734
Symptoms: The standby router crashes.
Conditions: This symptom is observed when a service-policy map is removed from a VC.
Workaround: There is no workaround.
• CSCsr28305
Symptoms: Connectivity issues are observed when using an L2 Port-Channel on a WS-X6708-10G
with two links as part of a Port-Channel.
Conditions: Member ports of the Port-Channel are on the same module and distributed different
fabric connections. Traffic stream is ingress and egress this Port-Channel. For example, default
gateway configuration for multiple VLANs, so traffic is ingressing and egressing this Port-Channel
when switching between VLANs.
Workaround: For usage of a Port-Channel with two member ports use interfaces which are on the
same fabric connection:
Fabric Channel #1: Ports 2, 3, 6, 8 Fabric Channel #2: Ports 1, 4, 5, 7
• CSCsr31518
Comentarios a estos manuales