Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 221

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 220
667
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
CSCsk94853
Symptoms: Bridge domain configuration not synchronized with standby router.
Conditions: Occurred on a Cisco 7600 router running Cisco IOS Release 12.2(33)SRC.
Workaround: Create the range first, exit the range, then apply the bridge-domain again.
CSCsl77577
Symptoms: Convergence time degraded 50%.
Conditions: This is seen when a low-cost link is shut and traffic is diverted to use the high-cost link.
The MPLS forwarding plane gets programmed with the new outgoing label.
Workaround: There is no workaround.
CSCsm97014
Symptoms: MLPoFR with the member group interface as crackerjack PA (PA-MC-2T3-EC) is
configured. On applying a simple policy along with RTP header compression virtual template, the
connectivity breaks.
Conditions: This is seen across PA (PA-MC-2T3-EC) and on applying both header compression and
QoS policy.
Workaround: There is no workaround.
CSCso07705
Symptoms: Tracebacks seen on Cisco 7200 router.
Conditions: Occurs when SSH is used to connect to Distributed Link Fragmentation and
Interleaving over Leased Lines (dLFIoLL) multilink IP address.
Workaround: There is no workaround.
CSCso42210
Symptoms: Following reload, controllers come up, but interfaces stay down.
Conditions: A router with HA Sup720 and non-HA Sup32 is connected with 8xCHT1/E1 SPA,
1xCHSTM1 SPA and 4xCT3 SPA in a SIP-200. Upon reloading 8xCHT1/E1 SPA alone on both
sides simultaneously, 6-7 interfaces go down and never come up. They show as up/up in line card
but up/down in RP.
Workaround: There is no workaround.
CSCso56733
Symptoms: Error messages and tracebacks in pm_get_standby_vlan.
Conditions: Occurs after adding more traffic engineering (TE) tunnels over port-channel interface
beyond the 1000 previously configured.
Workaround: There is no workaround.
CSCsq37953
Symptoms: Junk value is seen in stand-by router.
Conditions: Junk value is observed in stand-by router when normal ATM PVC is created. After
switch-over, junk value is seen in both active and stand-by routers.
Workaround: There is no workaround.
CSCsr01404
Symptoms: Multicast traffic is blocked due to duplicated interface tunnel configuration after Hot
Standby Routing Protocol (HSRP) failover.
Vista de pagina 220
1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 397 398

Comentarios a estos manuales

Sin comentarios