Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 193

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 192
639
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
Conditions: Occurs after a shut/no-shut on the ATM interface
Workaround: Reload the line card on both ends.
CSCsq60016
Symptoms: A router crashes after a long RSA key string is entered.
Conditions: This symptom is observed when a very long hex string is entered.
Workaround: Break the entry into shorter strings.
CSCsq77282
Symptoms: Creating a sub-interface may occasionally cause a traceback
Conditions: This may happen when configuring an ATM or SONET sub-interface.
Workaround: There is no workaround.
CSCsq77571
Symptoms: Router (SP) crash may happen upon deleting multiple VRFs or unconfiguring multiple
MDTs.
Conditions: The crash is seen when trying to delete multiple MDTs at one time.
Workaround: Allow at least seconds after each MDT delete command or VRF delete command
before issuing the next command.
CSCsr05746
Symptoms: ESM20 line card may crash while booting up.
Conditions: Occurs intermittently with a scaled topology.
Workaround: There is no workaround.
CSCsr09062
Symptoms: Cisco 7200 crashes due to memory corruption.
Conditions: Occurs when MLP+QoS is configured on a Cisco 7200 router. QoS policy is having
bandwidth, change the BW parameter and flap the multilink using clear int multilink1 to see the
crash.
Workaround: There is no workaround.
CSCsr18589
Symptoms: A Virtual Router Redundancy Protocol (VRRP) group configured on a VLAN interface
flaps from the backup to the master state after stateful switchover (SSO) when the existing master
is still available on the network. The group will flap back to backup a short period later.
Conditions: The problem only occurs when there are a large number of VLAN interfaces with a
VRRP group configured on each interface and SSO is performed.
Workaround: Each of the VRRP groups can be configured with a larger VRRP advert timer value.
Values should be varied depending on the setup, but a larger than default value is usually required.
CSCsr18942
Symptoms: Traceback occurs when VPN routing/forwarding (VRF) is deleted and then recreated.
Conditions: Occurs when multicast RP is configured under VPN routing/forwarding (VRF) first.
When the VRF is deleted, some multicast data may still be locked and not deleted, causing the
traceback when a new VRF is created and multicast RP is configured there.
Workaround: There is no workaround.
Vista de pagina 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 397 398

Comentarios a estos manuales

Sin comentarios