Cisco 7600-ES20-GE3CXL-RF - Ethernet Services 20G Line Card Switch Manual de usuario Pagina 231

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 398
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 230
677
Caveats for Cisco IOS Release 12.2(33)SRD through 12.2(33)SRD8
OL-10394-05 Rev. R0
CSCsr82917
Symptoms: A traceback is observed when an ANCP session is setup.
Conditions: This symptom occurs when setting up an ANCP session.
Workaround: There is no workaround.
CSCsr90248
Symptoms: Changing any of the parameters of a route-map does not take effect.
Conditions: Occurs when using a BGP aggregate-address with an advertise map.
Workaround: Delete the aggregate-address statement and then put it back for the change to take
effect.
CSCsr96042
Symptoms: ASR1000 Router crashes.
Conditions: Occurs if "ip vrf" is deleted from the configuration.
Workaround: There is no workaround.
CSCsr96468
Symptoms: The following may be seen on a Catalyst 3750 if an HSRP version 2 group is configured
after an HSRP version 1 group:
Vlan5 - Group 300 (version 2) State is Init (virtual MAC reservation failed)
The correct behavior is for the HSRP version 2 group to be rejected since the Catalyst 3750 only
supports MAC addresses for one HSRP version at any one time.
Conditions: This only affects the Catalyst 3750 platform.
Workaround: Remove the HSRP version 2 group.
CSCsr97753
Symptoms: Pinging an interface fails.
Conditions: Occurs when unconfiguring xconnect on the interface.
Workaround: Perform a shut/no shut on the interface.
CSCsu27888
Symptoms: IGMP v3 reports are discarded.
Conditions: Occurs on Cisco 7200 router running Cisco IOS Release 12.4(20)T2.
Workaround: There is no workaround.
CSCsu31444
Symptoms: A BR continuously displays errors messages on the console.
Router#%Error: timeout value is less than threshold 5000 %Error: timeout value is less
than threshold 5000 %Error: timeout value is less than threshold 5000 %Error: timeout
value is less than threshold 5000 %Error: timeout value is less than threshold 5000
%Error: timeout value is less than threshold 5000 %Error: timeout value is less than
threshold 5000 %Error: timeout value is less than threshold 5000 %Error: timeout value
is less than threshold 5000
OER jitter probes are not created because of this error.
Conditions: This symptom is observed with the jitter probe configuration below for VOIP
optimization:
Vista de pagina 230
1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 397 398

Comentarios a estos manuales

Sin comentarios